5-in-1 AIO flight controller using OpenVTX (up to 400mW), 12A ESC (BLHeli_S ESC), onboard FrSKY receiver (D8/D16), plugin connector for your motors and can take 1S or 2S batteries.

Notes: DO NOT FLASH THE BOARD WITH 4.3.1. There are SPI related issues when using 4.3.1. A fix is coming with a new firmware that will be available soon (4.3.2). STAY ON 4.3.0 OR BELOW.
Although D8 is still recomended, if using BF 4.3.0, you can now use D16 as well.

Notes: This is the V2 version capable of taking up to 2S.

Specifications:

FC:
Betaflight firmware target: CRAZYBEEF4FR
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: ICM42688P
Mount hole size: 25.5mm*25.5mm
Power supply: 1-2S battery input (DC 2.9V-8.7V)
Built-in 12A (each) Blheli_S 4in1 ESC
Built-in Betaflight OSD (SPI Control)
Built-in 5.8G OpenVTX 0mw~400mw
Built-in FrSKY D8/D16 Rx
Built-in voltage meter sensor: voltage meter scale 110
Built-in current meter sensor: current meter scale 470
Weight: 5.1g

4in1 ESC:
Power supply: 1-2S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Supports BLHeliSuite
Factory firmware: Z_H_30_REV16_7.HEX
Default protocol: DSHOT300
Supports Bluejay firmware
When using Bluejay firmware with 48khz, set startup power to 1100/1200

Receiver:
SPI BUS receiver
CC2500 RF
Compatible with Non EU transmitter D8 model Channels: 8ch
No ground interference ( Transmitter and receiver 1 m from the ground):
200meter failsafe supported
Supports Frsky D8/ D16 , Redpine , SFHSS

OpenVTX:
Firmware version: OPENVTX
Smartaudio v2.1
PIT mode supported
RACE mode supported
Channels: 48ch
Transmitting Power: 0/RACE/25mw/100mw/400mw
Power supply: DC 5V
Current (5v): <650ma (400mw)
Antenna connector: U.FL

Package:
1x X12 AIO Board
1x Dipole UFL Antenna
1x Camera cable
1x PH2.0 Pigtail
1x set of screws and grommets

Wiring diagram here

There are currently no product reviews.

Write Review

There are currently no videos