CrazybeeX DXS F4 1-2s AIO 5in1 flight controller built-in vtx/dsm2dsmx receiver/esc/osd

Write Review
Additional Information
  • Weight : 0.02
  • Model : CRFX-FRDXS
$54.99US
Qty :
CrazybeeX series flight controller is the first 4in1 AIO flight controller which could handle 2s.

The CrazybeeX DXS V1.0 is the newest member which is the first flight controller built-in DSM2/DSMX compatible SPI Receiver.

It’s a better upgrade for reduce the weight of your brushless whoop if you are using Spektrum transmitter. Best upgrade flight controller for Mobula6/Mobula6HD DSMX version .

Flight controller MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1S-2S battery input (DC 2.9V-8.7V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in SPI Frsky receiver support D8/D16
Built-in 5V 1A BEC
Built-in voltage detection
Firmware version Customized Betaflight4.3.0 S411
Onboard 4in1 ESC MCU upgraded to EFM8BB21
Power supply: 1-2S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.HEX
Default protocol: DSHOT600

Onboard DSM2/DSMX SPI receiver SPI BUS receiver DSM2/DSMX compatible
Channels: Max 12ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground):
200m~300m
RSSI enable(show on the goggles)

Onboard 5.8g VTX Output power: 25mw
Frequency: 40CH
Input voltage: 3.3V~5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels
With Race band
Smartaudio ready
Default vtx_power should set to be “3”

Onboard Voltage and Current detector Voltage Meter scale “110”
Amperage Mete scale “1175”

Notice: Recommend Betaflight configurator 10.7.0 version

SPI Receiver option: Spektrum

Bind procedure:
Plug the USB then press the bind button, the red LED at the bottom of the flight controller will blinking fast , this indicate the SPI DSM2/DSMX receiver is in bind mode.

Plug the USB then connect to Betaflight configurator, move to the CLI tab , then type “bind_rx”, the red LED at the bottom of the flight controller will blinking fast too , this indicate the SPI DSM2/DSMX receiver is in bind mode.

There are currently no product reviews.

Write Review

There are currently no videos

We Accept

Shopping Cart[more]

0 items