PRODUCT DESCRIPTION

FC // BLITZ F7 V1,1 Flight Controller

Top Features:
- Improved circuit design, better components and lower electrical noise!
- DJI HD VTX Connector (Plug-and-Play / No soldering required)
- FC indicator LEDs for visual debugging
- With LC filter

Specifications:
MCU: STM32 F722
Gyro: BMI270
Barometer: DPS310
OSD Chip: AT7456E
Flash: 32MB (Blackbox flash)
UARTS: 6
Motor outputs: 4x (SH1.0 connector)
I2C serial: SDA / SLA pads
Smartaudio / IRC Tramp VTX protocol supported
LED controller: Yes
Beeper pad: Yes
Firmware target: IFRC-IFLIGHT_BLITZ_F722
Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
Dimensions: 36.5*35 mm
Weight: 7.8g
BEC: 5V 2.5A / 9V 2A

Wiring suggestion:
- UART 1 for VTX HD / Analog
- UART 2 for a Receiver
- UART 3/4/5 for GPS or other sensors that require a serial port
- UART 6 for ESC Telemetry


Tips
1. F722 MCU has an inner inverter.
2. SBUS?CRSF?ELRS?IBUS?DSM ETC... can be connected to any unused UART_RX?we suggest you connect to Uart_RX2
3. Frsky SmartPort?Tramp & Smartaudio can be connected to any unused UART_TX?we suggest you connect to Uart_TX1
4. F.port can be connected to any unused UART_TX?we suggest you connect to Uart_TX2

ESC // BLITZ E45 4-IN-1 2-6S 45A ESC

Specification:
- Supports: DShot150/300/600/MultiShot/ OneShot etc.
- Mounting Holes: 30.5*30.5mm/?4mm
- Supports 2-6S lipo input
- Telemetry Output: NO
- Target: Q-H-25 16.7
- Current sensor: Yes
- Constant: 45 Amps
- Current rate: 200
- Burst: 55 Amps
- Weight: 14.7g
- MCU: BB21
- BEC: NO

PACKAGE INCLUDED:
- 1PC X BLITZ F7 V1.1 FLIGHT CONTROLLER
- 1PC X BLITZ E45S 4-IN-1 45A 2-6S ESC
- 1SET X SILICON GROMMETS
- 1SET X WIRE HARNESS FOR F7 FLIGHT CONTROLLER

There are currently no product reviews.

Write Review

There are currently no videos